Papers in 1997


  1. T. Fukui, T. Oobuchi, Y. Ikuhara, S. Ohara, K. Kodera, “Synthesis of (La,Sr)MnO3-YSZ composite particles by spray pyrolysis”,
    Journal of The American Ceramic Society, 80[1], 261-263 (1997).

  2. J. Gaze, T. Obata, N. Oyanagi, H. Izawa, W. L. Zhou, M. Kusunoki, and Y. Ikuhara, “The synthesis of diamond particles by a filament assisted CO2 laser induced CVD,”
    Nucl. Instrum. Methods. Phys. Res. B, 121[1-4], 427-431(1997).

  3. T. Hirayama, Y. Ikuhara, M. Nakamura, Y. Yamada, and Y. Shiohara, “Periodic fluctuation of Ba/Nd ratio in single crystals of high-J(c) NdBa2Cu3O7-delta superconductor,”
    J. Mater. Res., 12[2], 293-295(1997).

  4. Y. Ikuhara, P. Thavorniti, and T. Sakuma, “Solute segregation at grain boundaries in superplastic SiO2-doped TZP,”
    Acta Mater., 45[12], 5275-5284(1997).

  5. Y. Ikuhara, Y. Sugawara, I. Tanaka, and P. Pirouz, “Atomic and electronic structure of V/MgO interface,”
    Interface Sci., 5[1], 5-16(1997).

  6. Y. Ikuhara, I. Tanaka, P. Thavorniti, and T. Sakuma, “Grain boundary structure and chemical bonding state of superplastic SiO2-doped TZP,”
    J. Electron Microsc., 46[6], 467-472(1997).

  7. Y. Ikuhara, P. Thavorniti, T. Sakuma, “Grain boundary characterization of superplastic ceramics by HREM and AEM,”
    Materials Science Forum, 243-2, 345-350(1997).

  8. T. Kitamura, S. Taniguchi, I. Hirabayashi, S. Tanaka, Y. Sugawara, and Y. Ikuhara, “Introduction of pinning centers in superconducting YBCO thick film prepared by liquid phase epitaxy,”
    Ieee Trans. Appl. Supercond., 7[2], 1392-1395(1997).

  9. M. Kusunoki, Y. Ikuhara, Y. Shibata, and J. Kon, “Direct observation by TEM on the generation process of carbon clusters at 800 degrees C,”
    Fullerene Sci. Techn., 5[7], 1397-1405(1997).

  10. T. Nishimura, M. Mitomo, A. Ishida, H. Yoshida, Y. Ikuhara, and T. Sakuma, “Effect of Al2O3 on high temperature mechanical properties of silicon nitride with Yb4Si2O7N2,”
    J. Ceram. Soc. Jpn, 105[9], 801-804(1997).

  11. T. Sakuma, Y. Ikuhara, Y. Takigawa, and P. Thavorniti, “Importance of grain boundary chemistry on the high-temperature plastic flow in oxide ceramics,”
    Mater Sci Eng A Struct Mater, 234, 226-229(1997).

  12. Y. Shiohara, M. Nakamura, T. Hirayama, and Y. Ikuhara, “Single crystal growth of Nd123 superconductive oxides: New process to control critical currents,”
    J. Korean Phys. Soc., 31[1], 56-59(1997).

  13. Y. Sugawara, Y. Ikuhara, T. Kitamura, and I. Hirabayashi, “Lattice mismatch effects on the hetero interface structure of YBCO films grown by liquid phase epitaxy,”
    J. Jpn Inst. Met., 61[9], 942-950(1997).

  14. Y. Takigawa, Y. Ikuhara, T. Sakuma, “TEM characterization of grain boundaries in superplastic Al2O3-base ceramics,”
    Materials Science Forum, 243-2, 425-430(1997).

  15. P. Thavorniti, Y. Ikuhara, T. Sakuma, “Grain boundary analysis in superplastic SiO2-doped TZP,”
    Materials Science Forum, 233-2, 367-372(1997).

  16. H. Yoshida, K. Okada, Y. Ikuhara, and T. Sakuma, “Improvement of high-temperature creep resistance in fine-grained Al2O3 by Zr4+ segregation in grain boundaries,”
    Phil. Mag. Lett., 76[1], 9-14(1997).