Menu
[1] T. Fukui, T. Oobuchi, Y. Ikuhara, S. Ohara, and K. Kodera, “Synthesis of (La,Sr)MnO3-YSZ composite particles by spray pyrolysis,” Journal of the American Ceramic Society, 80[1], 261-263(1997).
[2] J. Gaze, T. Obata, N. Oyanagi, H. Izawa, W. L. Zhou, M. Kusunoki, and Y. Ikuhara, “The synthesis of diamond particles by a filament assisted CO2 laser induced CVD,” Nuclear Instruments & Methods in Physics Research Section B-Beam Interactions with Materials and Atoms, 121[1-4], 427-431(1997).
[3] T. Hirayama, Y. Ikuhara, M. Nakamura, Y. Yamada, and Y. Shiohara, “Periodic fluctuation of Ba/Nd ratio in single crystals of high-J(c) NdBa2Cu3O7-delta superconductor,” Journal of Materials Research, 12[2], 293-295(1997).
[4] Y. Ikuhara, Y. Sugawara, I. Tanaka, and P. Pirouz, “Atomic and electronic structure of V/MgO interface,” Interface Science, 5[1], 5-16(1997).
[5] Y. Ikuhara, I. Tanaka, P. Thavorniti, and T. Sakuma, “Grain boundary structure and chemical bonding state of superplastic SiO2-doped TZP,”Journal of Electron Microscopy, 46[6], 467-472(1997).
[6] Y. Ikuhara, P. Thavorniti, and T. Sakuma, “Solute segregation at grain boundaries in superplastic SiO2-doped TZP,” Acta Materialia, 45[12], 5275-5284(1997).
[7] T. Kitamura, S. Taniguchi, I. Hirabayashi, S. Tanaka, Y. Sugawara, and Y. Ikuhara, “Introduction of pinning centers in superconducting YBCO thick film prepared by liquid phase epitaxy,” Ieee Transactions on Applied Superconductivity, 7[2], 1392-1395(1997).
[8] M. Kusunoki, Y. Ikuhara, Y. Shibata, and J. Kon, “Direct observation by TEM on the generation process of carbon clusters at 800 degrees C,”Fullerene Science and Technology, 5[7], 1397-1405(1997).
[9] T. Nishimura, M. Mitomo, A. Ishida, H. Yoshida, Y. Ikuhara, and T. Sakuma, “Effect of Al2O3 on high temperature mechanical properties of silicon nitride with Yb4Si2O7N2,” Journal of the Ceramic Society of Japan, 105[9], 801-804(1997).
[10] T. Sakuma, Y. Ikuhara, Y. Takigawa, and P. Thavorniti, “Importance of grain boundary chemistry on the high-temperature plastic flow in oxide ceramics,” Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing, 234, 226-229(1997).
[11] Y. Shiohara, M. Nakamura, T. Hirayama, and Y. Ikuhara, “Single crystal growth of Nd123 superconductive oxides: New process to control critical currents,” Journal of the Korean Physical Society, 31[1], 56-59(1997).
[12] Y. Sugawara, Y. Ikuhara, T. Kitamura, and I. Hirabayashi, “Lattice mismatch effects on the hetero interface structure of YBCO films grown by liquid phase epitaxy,” Journal of the Japan Institute of Metals, 61[9], 942-950(1997).
[13] H. Yoshida, K. Okada, Y. Ikuhara, and T. Sakuma, “Improvement of high-temperature creep resistance in fine-grained Al2O3 by Zr4+ segregation in grain boundaries,” Philosophical Magazine Letters, 76[1], 9-14(1997).